Home > Disposal Repair Atlanta
We repair all brands and models for garbage disposal units in Atlanta.
If your garbage disposal doesn't turn, it’s leaking or something
else is wrong with the unit, just call our toll free number and
we will take care of the rest. Our Atlanta garbage disposal repair
technicians are available 24/7 at our toll free number:
800-643-7161
Please note: We have parts on hand for disposal repairs but do not sell parts to customers.
Since attempting garbage disposal repairs can be dangerous,
in many instances work should only be undertaken by a qualified
professional. And certainly the money you've saved by doing your
own garbage disposal repairs will be of little benefit if a careless
accident sends you to the emergency room. For this reason, let the
professional who is familiar and experienced with technical safety
work on your garbage disposal repairs. Call us 24/7 for professional
garbage disposal repair at our toll free number:
800-643-7161
GARBAGE DISPOSER ELECTRICAL CONNECTION
1. Connect disposer to 115-volt, 60-cycle alternate current (AC)
only.
2. A junction box should be installed either in the cabinet compartment
under the sink or in a removed location.
3. Mount standard amperes toggle switch near the sink, within easy
reach of the user.
4. Use BX cable. Install BX connector in hole provided in bottom
of disposer. Connect white wire in BX cable to white lead and black
wire in BX cable to black lead. If BX cable is not used, provide
a separate ground wire to nearest cold-water pipe or other suitable
ground, using screw on bottom and bell for third wire.
5. If plug-in cord is used, it should be 30 inches long with a male
connection of the parallel blade two-pole, three-wire type. Ground
wire should be attached to a screw on the bottom end bell.
6. This appliance is equipped with copper lead wires. If connection
is made to aluminum house wiring, use only special connectors that
are approved for joining copper and aluminum wires in accordance
with the National Electrical Code and local codes and ordinances.
7. Make all installations in accordance with local electrical codes
and ordinances where installation is made.
Grounding. It is recommended that the electrical hook-up be like
the type, with a ground wire. If the supply source does not have
a ground, then a ground wire must be run from screw inside bottom
cover of disposer to grounded metal cold water line. Make certain
wire is securely clamped to the pipe.
800-643-7161
|
